TM 10-5410-224-14
REPAIR OF FOLDOUT END WALLS
(b) Remove 40 rivets (2) to detach hinge
6-1. Description.
half (5).
The description of the foldout end walls is
(c) Replace both hinge (3) halves (5 and 6)
contained in paragraph 3-18.
by securing with 40 rivets (2) and 40 rivets (1),
6-2. Removal.
respectively.
Most foldout end wall repairs can be ac-
(2) Removal and replacement of seal (fig. 4-3).
complished without removing the wall from the
To remove and replace seal (9), proceed as follows:
shelter. Therefore, do not remove the wall unless it
(a) Remove rivets (7) to detach seal strip
is absolutely necessary.
(8).
6-3. Cleaning.
NOTE
Refer to paragraph 4-7 for rivet removal and
Use a clean, soft bristle brush to remove dust,
replacement procedures.
dirt, and lint from all parts and surfaces of the
(b) Remove and replace seal (9) in ac-
sidewall. Wash walls with soap and water, and a
cordance with instructions given in paragraph 3-
sponge or soft cloth.
(c) Re-attach seal strip (8) using rivets (7).
a. Inspection. Inspection of the foldout end
(3) Removal and replacement of latch and pan
walls is accomplished by performing the following
procedure:
(19), proceed as follows:
(1) Perform inspection procedure of paragraph
(a) Remove four rivets (15) to detach latch
(16).
(2) Check condition of ventilation fan and air
NOTE
conditioner panels.
Refer to paragraph 4-7 for rivet removal and
replacement procedures.
b. Repair. If a foldout end wall has minor
structural damage, repair the wall in accordance
(b) Remove 10 rivets (17) to detach pan
with procedures given in paragraph 3-16. If a wall
(18).
has major damage, replace the entire wail making
(c) Replace pan (18) by securing to foldout
sure that the new wall meets the requirements of
end wall using 10 rivets (17).
Brunswick drawings. If a part attached to a
(d) Replace latch (16) by securing to foldout
foldout end wall is damaged, remove and replace
end wall using four rivets (15).
the damaged part as follows:
(4) Removal and replacement of seal frame
(1) Removal and replacement of hinge (fig. 4-
assembly (fig. 6-1). To remove and replace seal
frame assembly (5), proceed as follows:
follows:
(a) Detach seal frame assembly (5) from
(a) Remove 40 rivets (1) to detach hinge half
foldout end wall.
(b) Refer to paragraph 3-16 for seal removal
(6).
and replacement instructions.
NOTE
Refer to paragraph 4-7 for rivet removal and
(c) Replace seal rubber (6) in seal frame
replacement procedures.
(7) and secure seal frame assembly in foldout end
wall.
