TM 10-5410-224-14
1. Seal assembly
5. Frame assembly
2. Seal
6. Seal
3. Plate
7. Frame
4. Seal
(5) Removal and replacement of jack support
To remove and replace ECU panel (31), proceed as
port plate (12), proceed as follows:
follows:
(a) Remove jack from jack support plate
(a) Detach cable (6) from foldout end wall
(12).
by removing screw (1) and shoulder washers (3 and
(b) Remove two screws (10) and washers
4).
(11) to detach jack support plate.
(b) Remove seven rivets (7) from hinge (10)
(c) Replace jack support plate (12) by
and remove ECU panel (31 ) from foldout end wall.
securing to foldout end wall using two screws (10)
NOTE
and washers (11).
replacement procedures.
(d) Install jack in accordance with
(c) Replace ECU panel (31) by attaching
(6) Removal and replacement of inserts (fig. 4-
hinge to foldout end wall using rivets (7).
3). To
remove and
replace inserts (13), follow
(d) Re-attach cable (6) to foldout end wall
with screw (1) and shoulder washers (2 and 3).