TM 10-5410-224-14
NOTE
(9) Removal and replacement of hinge (fig. 6-
Refer to paragraph 4-7 for rivet removal and
replacement procedures.
follows:
(a) Remove ECU panel as described in
(b) Replace retainer plate (25) by securing
subparagraph 6-4b(7).
to ECU panel using two rivets (24).
(11) Removal and replacement of lock plate
(b) Remove 10 rivets (9) to detach hinge
(10) from ECU panel (31).
proceed as follows:
NOTE
Refer to paragraph 4-7 for rivet removal and
(a) Remove screw (28) to detach lock plate
replacement procedures.
(29).
(b) Replace lock plate (29) by securing to
(c) Replace hinge (10) by securing to ECU
ECU panel using screw (28).
panel (31 ) with 10 rivets (9).
(d) Replace ECU panel as described in
6-5. Installation.
subparagraph 6-4b(7).
If entire foldout end wall is to be replaced,
(10) Removal and replacement of retainer
refer to the installation procedure contained in
plates (fig. 6-2). To remove and replace retainer
plates (25), proceed as follows:
(a) Remove two rivets (24) to detach
retainer plate (25).
6-4
