TM 10-5410-224-14
6. Rivet (31)
1. Pin
7. Fastener (2)
2. Fastener (2)
8. Fastener (2)
3. screw (2)
9. Hinge
4. Washer (2)
10. Nut (2)
5. Rivet (31)
(9) Turn all circuit breakers on circuit breaker
b. Installation. To install the swingout walls on
panel to the on position (see fig. 2-1).
the expandable shelter perform the following
procedure:
(1) Carefully place swingout wall on ex-
a. Removal. To remove the foldout end walls
pandable shelter so that it aligns with the hinge on
from the expandable shelter, perform the following
the center structure end panel.
procedure:
(2) Support swingout wall and attach to hinge
(1) Perform preliminary procedure of
with screws and rivets.
(3) Secure swingout wall to foldout floor panel
(2) Disconnect and remove ECU or ventilation
and foldout end wall using two latches (4, fig. 4-2)
fan from foldout end wall about to be removed.
and three latches (8).
(3) Release latches (fig. 3-2) securing safety
(4) Using roof support struts, lower hinged
cables to personnel and cargo end panels where
roof panel until it rests on swingout walls and
foldout end wall is about to be removed.
foldout end wall.
(4) Remove leveling jacks (fig. 3-4) from
(5) Remove struts from roof, and place them
corners of expandable shelter where foldout end
in stowed position on side of shelter. Pin struts to
wall is about to be removed.
secure.
(5) Unpin roof support struts from stowed
(6) Secure foldout roof panel to both swingout
position on one side of expandable shelter. Place
walls and foldout end wall using two latches (4,
struts in position to support foldout roof panel on
section where foldout end wall is being removed
(7) Reconnect tie down cables.
(6) Inside shelter, release two latches (4, fig.
(8) Reconnect electrical cabling and com-
ponents in accordance with table 2-1, and in-
stallation procedures of paragraph 3-26c.
