TM 10-5410-224-14
(6) Disconnect five leads from circuit breaker
Site power must be disconnected from the
CB1 (4).
power entrance panel by a qualified
(7) Remove eight screws (11) and washers (12
electrician.
and 13) securing circuit breaker panel to shelter
(3) Disconnect site power from power entrance
wall.
panel (refer to paragraph 3-4, step b.).
(8) Remove circuit breaker panel.
(4) Disconnect five cables from top of circuit
b. Installation,
breaker panel (6, fig. 4-7). It is not necessary to
(1) Place circuit breaker panel (6, fig. 4-7) in
disconnect light at top of circuit breaker panel.
position on inside rear of electrical power entrance
(5) Remove four screws to remove panelboard
panel (fig. 3-1) on personnel end panel.
cover (10).
