Figure 4-2. Front Bracket Mounting Assembly

Figure 4-1. Rear Bracket Mounting Assembly

Mounting Shelter on Vehicle - TM-10-5411-224-14_27

TM-10-5411-224-14 Lightweight Multipurpose Shelters (LMS) Model No. S-78B/G Type I and Type III & 5411-01-357-3683 Manual
Page Navigation
17

TM 10-5411-224-14 c. Front Shelter Preparations. (Refer to Figure 4-2) (1) Remove bolts/plugs from the front and bottom front surfaces of the shelter. CAUTION Do not use excessive force when tightening bolts. Damage to equipment may occur. (2) Set mounting angle assembly (1) to shelter and secure front section with screws (2), lockwashers (3), flat washers (4) and bottom section with bolts (5) and flat washers (6). Tighten screws/bolts to 8-10 ft-lbs. (3) Insert screw (7), flat washer (8), isolator mount washer (9), and isolator (10) into each slot of mounting angle assembly (1). (4) Repeat steps 1 through 3 for other side of shelter. Figure 4-2. Front Bracket Mounting Assembly 4-4 CHANGE 1

Privacy Statement
Press Release
Contact