TM 10-5411-224-14CHAPTER 4UNIT MAINTENANCE INSTRUCTIONSSECTION I. REPAIR PARTS; TOOLS; SPECIAL TOOLS; TESTMEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORTEQUIPMENT4-1. COMMON TOOLS. A complete list of common tools and tool kits may be found in Section III of Appendix B,Maintenance Allocation Chart.4-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. There are no special tools or test equipment needed tomaintain the LMS.4-3. REPAIR PARTS. Repair parts for unit maintenance are listed and illustrated in the Repair Parts and Special ToolsList (RPSTL), TM 10-5411-224-24P.SECTION II. SERVICE UPON RECEIPT4-4. SERVICE UPON RECEIPT OF SHELTER. Inspect shelter for damage incurred during shipment. If the shelter hasbeen damaged, report the damage in accordance with the instructions in the Warranty Technical Bulletin, TB 10-5411-224-14. If the shelter is crated or pallet mounted, refer to the end item technical manual for unpacking instructions. Ifthe shelter is to be loaded onto a new HMMWV, perform the following:NOTE•For shelters to be replaced or moved from one vehicle to another and for any component of the installation mountingkit which requires maintenance, perform only the steps which are applicable.•Prior to performing the following procedures, remove Shelter-To-Vehicle Mounting Kit and inventory per Table C-1.a.Vehicle Preparations. (Refer to Figure 4-1)(1)Remove wheel well side panels located on each side of vehicle per TM 9-2320-280-20.(2)Carefully feed antenna cable back through wheel well grommet, place protective cap over connectors, andsecure cables behind cross member support in wheel well.(3)From inside the curbside rear wheel well, remove the wiring harness clamp mounting bracket.CHANGE 1 4-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
