TM 10-5411-224-14
(4)
Remove cable clamps from wiring.
(5)
Remove tail lights from HMMWV lower frame per TM 9-2320-280-20. Retain hardware.
(6)
Secure tail lights (1) to tail light mounting brackets (2) using bolts and washers removed in step (5).
(7)
Make a single cut through grommet and place it around the tail light wiring.
(8)
Remove camlock fasteners from the vehicle mounting beam located in the front of the vehicle's bed,
both sides. Refer to TM 9-2320-280-20.
(9)
Remove strap tie down ring from the front of the bed floor, passenger side. Refer to TM 9-2320-280-20.
b.
Rear Shelter Preparations (Refer to Figure 4-1)
WARNING
Be sure shelter is properly positioned on support stands capable of supporting 2000 Lbs.
Failure to observe safety procedures when working under the shelter could result in severe
injury or death.
CAUTION
Do not use excessive force when tightening nuts. Damage to the equipment can occur.
NOTE
During procedure, threaded holes may be fouled with paint/primer/sealer preventing full
insertion of bolts. Should this occur use a bottom tap to clean foreign matter from holes.
(1)
Secure clamping bracket and shim (3) to rear mounting bracket (4) using screw (5), flat washer (6),
lockwasher (7), and nut (8). Do not tighten.
(2)
Remove nuts (9), bolts (10), lockwashers (11), flat washers (12) securing curbside rear bumper to vehicle
frame. Retain nuts (9), lockwashers (11) and flat washers (12).
(3)
Position and secure rear mounting bracket (4) to rear bumper using (new) longer bolts (10) -and fiat
washers (12), lockwashers (11), and nuts (9). Do not tighten bolts.
(4)
Locate tail light mounting bracket (2) with tail light (1) to rear mounting bracket (4) and secure with screw
(13), flat washer (14), lockwasher (15), and nut (16).
(5)
Insert tail light wiring connectors through hole in rear mounting bracket (4), across top of rear bumper and
reconnect to vehicle wiring harness. Install grommet (29) in hole in rear mounting bracket (4).
4-2 CHANGE 1
