SECTION III. OPERATOR MAINTENANCE PROCEDURES

TABLE 3-1. OPERATOR TROUBLESHOOTING - TM-10-5411-224-14_21

CHAPTER 4 UNIT MAINTENANCE INSTRUCTIONS - TM-10-5411-224-14_23

TM-10-5411-224-14 Lightweight Multipurpose Shelters (LMS) Model No. S-78B/G Type I and Type III & 5411-01-357-3683 Manual
Page Navigation
13

TM 10-5411-224-14 SECTION III. OPERATOR MAINTENANCE PROCEDURES 3-3. GENERAL. The LMS is delivered with no internally installed equipment or provisions. Operator level maintenance and repair addresses shelter exteriors or easily accessible interior areas. Do not operate electrical equipment when floors, ceilings, or walls show evidence of water intrusion. Notify your supervisor if any of the following conditions exist: a. Structural. Panel damage spans a structural member. b. Wall, Ceiling. and Floor Panels. Replacement of an entire wall, ceiling, or floor is required. c. Unauthorized Removal of Equipment. Extensive removal of equipment is necessary that is beyond the capability of the maintenance support activity. d. Welding. Welding is required. e. Distortion of Panels. Damage to a structural member is severe enough to cause distortion of a wall, especially an edge or corner area. f. Non-visible Damage Assessment. Lift eye or corner castings are damaged severely enough to indicate possible damage to the underlying structural member. 3-4. GENERAL REPAIR PROCEDURES. General repair procedures at the operator level are limited to inspection, cleaning and touch-up painting. The following procedures identify the operator repair procedures for the items listed in the troubleshooting table. 3-5. INSPECTION PROCEDURES. Periodic inspections must be made by operators and maintenance personnel to insure that any defects or hazardous conditions are detected and corrected. Those items that require frequent inspection and maintenance to insure the operational integrity of the shelter are listed in table 2-1 and the Maintenance Allocation Chart in Appendix B. 3-6. CLEANING PROCEDURES. Use a vacuum cleaner to remove dust and dirt from places that are difficult to access otherwise. Use a mild detergent solution with water to clean interior and exterior surfaces. The exterior of the LMS shelter can be rinsed with water to remove accumulation of dirt. 3-7. TOUCH-UP PAINTING. When required to prevent rust and corrosion, touch up small areas of damaged or chipped paint in accordance with TM 43-0139. If large areas need repainting, notify your supervisor. 3-3/(3-4 blank)

Privacy Statement
Press Release
Contact