Table 2-2. Decals and Instruction Plates

Table 2-1. Operator Preventive Maintenance Checks and Services for LMS. (cont)

Figure 2-1. Decals and Instruction Plates

TM-10-5411-224-14 Lightweight Multipurpose Shelters (LMS) Model No. S-78B/G Type I and Type III & 5411-01-357-3683 Manual
Page Navigation
8

TM 10-5411-224-14 (1) Loosen retaining strap securing ladder to the door assembly and lift ladder off of the stowage brackets. (2) Place ladder hooks in slotted brackets located below the personnel door to provide access into shelter. c. Installation Instructions. Tighten the drain plug which was loosened for shipment. 2-5. INITIAL ADJUSTMENTS. a. Routine Checks. Routine checks include the inspection of the door for missing or loose hardware and all interior and exterior surfaces for damage. Check the door for a secure fit. Surface area checks should include inspection for paint damage, corrosion, dents, cracks and punctures. b. Adjustments. The LMS shelter is ready for use upon receipt and requires no additional adjustments. Refer to the end item technical manual for initial adjustments. 2-6. OPERATING PROCEDURES. There are no operating procedures set aside for the LMS excepting the initial set-up procedures. Refer to the end item technical manual for additional instructions applicable to the shelter configuration. 2-7. DECALS AND INSTRUCTION PLATES. The decals and instruction plates are located on the shelter as shown in figure 2-1. 2-8. PREPARATION FOR MOVEMENT. The LMS is designed for operation at a stationary site. The following instructions detail the procedures for preparing for a movement. a. Close personnel door. b. Lift ladder off of the bracket and place hooks in the slotted stowage brackets on the personnel access door. Secure ladder in place using the retaining strap. Table 2-2. Decals and Instruction Plates INDEX ITEM DESCRIPTION 1 IDENTIFICATION PLATE Provides pertinent shelter information including nomenclature, type, serial number and other manufacturer data. 2 PAINT INSTRUCTION PLATE The surfaces of this shelter have been painted with CARC For touch-up Epoxy primer IAW MIL-P-53022. Exterior - Use only lusterless green color no. 34094, polyurethane IAW MIL-C- 46168, type II. Interior - Use only semi-gloss white, color no. 27875 and light green, color no. 24533, epoxy polyamide IAW MIL-C- 22750. 3 AIRCRAFT LOADING DATA PLATE Provides aircraft loading data. 2-5

Privacy Statement
Press Release
Contact