TM 10-5411-224-14(6)Position bar assembly (12) under the vehicle mounting beam (7) and thread the mounting screws of thethree outside isolator assemblies into the bar assembly (12). Do not tighten.(7)Place flat washer (13) and self locking nut (14) on the inside isolator mounting screw (6). Do not tighten.(There is no isolator washer in this mounting hole).(8)Repeat for other side of shelter.(9)Raise rear of the shelter just far enough to allow access between the rear mounting brackets (16) and rearmounting adapters (15). Loosen front mounting screws more if more clearance is required.(10)Due to potential variations in the HMMWV or shelter length and width, carefully align each mounting screw(20) with holes on rear mounting bracket (16). Using the slotted holes in the respective pieces, adjust the mountingbracket (16) for any lateral movement required and the mounting adapter (15) for any longitudinal movement required.(11)Tighten all bolts and screws securing the rear mounting bracket (16) to the rear bumper and rear mountingadapter(15) to shelter floor and sides.(12)Slide isolator (17), isolator spacer (18), and sleeve spacers (19) onto each mounting screw (20) betweenrear mounting brackets (16) and rear mounting adapter (15) (13) Slowly lower the shelter, maintaining alignment, andslide isolators (17) isolator washers (21 and flat washers (22) onto each mounting screw (20) secure with self locking nut(23). Do not tighten.(14)Repeat for other side.CAUTIONDo not use excessive force when tightening bolts. Damage to equipment may occur.(15)Recheck and tighten all screws/nuts to 8-10 ft-lbs.(16)Lower the shelter all the way and remove the lifting sling from the lift rings.4-6 CHANGE 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
