RAMP EDGE PROTECTOR MAINTENANCE INSTRUCTIONS (TYPE I AND TYPE II, CLASS A)

Section II. SERVICE UPON RECEIPT - TM-10-5411-203-13_66

RAMP END PLATE ASSEMBLY MAINTENANCE INSTRUCTIONS

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
62

TM 10-5411-203-13 4-6. RAMP EDGE PROTECTOR MAINTENANCE INSTRUCTIONS (TYPE I AND TYPE II, CLASS A) This task covers: Replace INITIAL SETUP Parts/Materials Ramp edge protector Equipment Condition Ramp taken out of service. (Refer to para 2-5.) REMOVE CAUTION Do not step on fabric floor of connector assembly when ramp is not in place. Damage to connector assembly may result. Remove edge protector (1) by sliding it off edge of ramp end plate assembly (2). INSTALL Slide edge protector (1) onto ramp end plate assembly (2). NOTE FOLLOW-ON MAINTENANCE: If required, place ramp in service. (Refer to para 2-4.) 4-2

Privacy Statement
Press Release
Contact