RAMP THRESHOLD CHANNEL MAINTENANCE INSTRUCTIONS (TYPE II, CLASS A ONLY)

RAMP END PLATE ASSEMBLY MAINTENANCE INSTRUCTIONS (TYPE II, CLASS A ONLY) (CONT

STAIRWAY RISER AND SUPPORT ASSEMBLIES MAINTENANCE INSTRUCTIONS

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
65

TM 10-5411-203-13 4-8. RAMP THRESHOLD CHANNEL MAINTENANCE INSTRUCTIONS (TYPE II, CLASS A ONLY) This task covers: Replace INITIAL SETUP: Tools Drill, electric, portable (Appendix B, Section III, Item 3) Drill set, twist (Appendix B, Section III, Item 4) Stake, sheetmetal working (Appendix B, Section III, Item 8) Tool kit, general mechanic's (Appendix B, Section III, Item 1) Parts/Materials Threshold channel Threshold channel liner Rivets, solid (Appendix D, Item 8) Equipment Condition Ramp assembly disassembled. (Refer to para 4-7.) REMOVE CAUTION Do not step on fabric floor of connector assembly when ramp is not in place. Damage to connector assembly may result. Drill out rivets that secure threshold channel liner to threshold channel. INSTALL 1. Insert threshold channel liner into threshold channel, aligning holes. 2. Install six rivets. NOTE FOLLOW-ON MAINTENANCE: 1. Assemble ramp (refer to para 4-7), and 2. if required, place ramp in service (refer to para 2-4). 4-5

Privacy Statement
Press Release
Contact