STAIRWAY PIN AND LANYARD ASSEMBLY MAINTENANCE INSTRUCTIONS

STAIRWAY RISER AND SUPPORT ASSEMBLIES MAINTENANCE INSTRUCTIONS

EXTERIOR FRAME ASSEMBLY HEADER BAR MAINTENANCE INSTRUCTIONS

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
67

TM 10-5411-203-13 4-10. STAIRWAY PIN AND LANYARD ASSEMBLY MAINTENANCE INSTRUCTIONS (TYPE II, CLASS B ONLY) This task covers: Replace INITIAL SETUP: Parts/Materials Pin and lanyard assembly Sleeve, swaging Equipment Condition Stairway assembly removed from service. (Refer to para 2-4.) REMOVE Remove any remaining portion of pin and lanyard assembly. INSTALL 1. Feed free end of wire rope (1) through the swaging sleeve (2) and on through the appropriate hole in stairway section. 2. Form a loop and feed the free end through the swaging sleeve. The correct loop size is attained by working with the stripped end of the wire rope. 3. Hold the assembly in place and crimp sleeve with slip joint pliers. 4. Check the holding strength of the replaced assembly. NOTE FOLLOW-ON MAINTENANCE: If required, place stairway assembly in service. (Refer to para 2-5.) 4-7

Privacy Statement
Press Release
Contact