TM 10-5411-203-13
CHAPTER 4
UNIT MAINTENANCE
Section I.
REPAIR PARTS; SPECIAL TOOLS; TEST MEASUREMENT, AND
DIAGNOSTIC EQUIPMENT (TMDE; AND SUPPORT EQUIPMENT
4-1.
COMMON TOOLS AND EQUIPMENT. For authorized common tools and equipment, refer to the Modified
Table of Organization and Equipment applicable to your unit.
4-2.
SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT. There are no special tools required for the
Complexing Kit Passageway. For TMDE and sup- port equipment, refer to the Maintenance Allocation Chart (Appendix
B).
4-3.
REPAIR PARTS. Repair parts for the Complexing Kit Passageway are listed and illustrated in TM 10-5411-203-
23P, Unit and Direct Support Repair Parts and Special Tools List for Complexing Kit Passageway Type I and Type II. For
initial issue, selected spare/repair parts are provided as Basic Issue Items and are listed and illustrated in Appendix C,
Section III of this manual.
Section II.
SERVICE UPON RECEIPT
4-4.
SERVICE UPON RECEIPT OF MATERIEL. The unit maintenance technician should inspect the equipment
before it is used. The technician will make the following checks when the equipment is unpacked:
a.
Inspect the equipment using the preventive maintenance checks and services listed in paragraph 2-2. If the
equipment has been damaged in shipment, report the damage on DD Form 6, Packaging Improvement Report.
b.
Check the equipment against the packing list to see if the ship- ment is complete. Report all discrepancies in
accordance with DA PAM 738-750.
c.
Check to see whether the equipment has been modified.
d.
Service damaged equipment, as necessary, using unit maintenance procedures in Section III of this chapter to
restore equipment to operable condition.
Section III.
MAINTENANCE PROCEDURES
4-5.
GENERAL. This Section contains maintenance instructions authorized by the Maintenance Allocation Chart
(Appendix B) to the unit maintenance level. Unit maintenance personnel can perform all maintenance at the operator
level.
4-1
