AREA LIGHT ASSEMBLY TESTING AND REPAIR (cont)

AREA LIGHT ASSEMBLY TESTING AND REPAIR (cont) - TM-10-5411-201-14_102

INCANDESCENT LIGHT ASSEMBLY TESTING, REPLACEMENT AND REPAIR - TM-10-5411-201-14_104

TM-10-5411-201-14 Shelter Tactical Expandable One-Sided NSN 5411-01-124-1377 60 AMP Model NSN 5411-01-295-3433 100 AMP Model Manual
Page Navigation
84

TM 10-5411-201-14 T.O. 35E4-178-1 4-9. (cont) 8. Connect three wires from electrical cord (9) to three wires from lamp holder (2) as follows: From To Electrical Cord Lamp Holder Black Wire Black Wire White Wire White Wire Green Wire Bare Wire 9. Secure these wires with three wire nuts (8). 10. Make sure connected wires are positioned in opening at top of exterior light post (10) and assemble gasket (7) and outlet cover (6) to top of exterior light post (10) with two captive screws (5). 11. Install flood light (1) in lamp holder (2). 4-10. INCANDESCENT LIGHT ASSEMBLY TESTING, REPLACEMENT AND REPAIR This task covers. a. Testing d. Repair b. Removal e. Installation c. Cleaning, Inspection INITIAL SETUP Standard Tools Personnel General mechanics tool kit Electrician Test Equipment Multimeter, Appendix B, Item 4 WARNING This fixture dangerous if incandescent circuit br contains voltage that is contacted. Before replacing light assembly, set all eakers and switches to OFF Position. TESTING 1. Set all circuit breakers and switches to OFF position. 2. Remove two screws (1) and cover (2). 3. Unscrew bulb (3) from light fixture (4). 4-21

Privacy Statement
Press Release
Contact