POWER ENTRY PANEL ASSEMBLY TESTING, REPLACEMENT, AND REPAIR (cont)

POWER ENTRY PANEL ASSEMBLY TESTING, REPLACEMENT, AND REPAIR (cont) - TM-10-5411-201-14_97

POWER ENTRY PANEL ASSEMBLY TESTING, REPLACEMENT, AND REPAIR (cont) - TM-10-5411-201-14_99

TM-10-5411-201-14 Shelter Tactical Expandable One-Sided NSN 5411-01-124-1377 60 AMP Model NSN 5411-01-295-3433 100 AMP Model Manual
Page Navigation
79

TM 10-5411-201-14 T.O. 35E4-178-1 4-8. (cont) Terminals/Connectors 7. 8. 9. 10. Inside shelter, remove screws (l), lockwashers (2), and washers (3), and carefully lift cover assembly (4) away from personnel door end endwall panel as far as it will go. Disconnect wires from terminals/connectors at rear of panel (5). NOTE Tag all wires for reconnection. Remove rubber cap (21), nut (22), lockwasher (23), brass washer (29), nylon washer (30), two O-rings (31), nylon washer (32), and binding post body (33) from panel (5). Remove four nuts (24), three lockwashers (25), three washers (26), terminal lug (27), and threaded stud (28) from panel (5). CLEANING, INSPECTION 1. Clean power entry panel and component surfaces. 2. Inspect mounting surfaces for corrosion and damage. 3. Inspect for damaged receptacles, binding posts, terminals, or threaded stud. 4-16

Privacy Statement
Press Release
Contact