TM 10-5411-201-14
T.O. 35E4-178-1
4-9.
(cont)
3.
Inspect for and replace if necessary:
a.
Missing or damaged components
b.
Corrosion or paint damage.
REPAIR
Repair corrosion or paint damage.
(Refer to paragraph 4-44)
ASSEMBLY
1.
2.
3.
4.
5.
6.
7.
Position two cord stowage brackets (20) on exterior light post (10)
and install four rivets (19).
(Refer to paragraph 4-33)
Install two bolts (18), washers (17), and wing nuts (16) in exterior
light post (10).
Assemble three terminal lugs (15) to three wires on one end of
electrical cord (9) and attach connector (14) at that end.
Place electrical cord (9) through clamp (12) and attach clamp to
exterior light post with two rivets (11) and close clamp.
(Refer to
paragraph 4-33)
Assemble liquid tight connector (13) to opposite end of electrical
cord (9) and install assembly in exterior light post (10). Make
sure three wires extend through opening at top of exterior light
post (lo).
Assemble locknut (21) on lamp holder (2).
Assemble lamp holder (2) to exterior light post (10) and install
thumb screw (4) and wing nut (3). Make sure three wires extend
through opening at top of exterior light post (10).
4-20
