TM 10-5410-230-13
2-6. INSTALLING THE S-250E BOOT WALL TYPE IV (CONT).
m. Wrap remainder of boot assembly (2) around S-250E shelter and thread web belly band (4) through dee-ring buckle
(5) and tighten.
n. Fasten upper and lower portions of boot assembly (2) together with hook and pile fastener tapes (6) on driver's side.
o. Insert telescopic poles (1) into second and third loops (2) and bottom grommet (3).
p. Extend poles (1) by raising upper portion thru upper loop (4) and inner grommet (5) at top of Boot Wall until Boot
Wall is taut.
q. Secure guy lines (6) (Appendix C, Section III, Item 1) from outer grommet (7) on each side of Boot Wall by staking
into ground with tent stakes (8) (Appendix C, Section III, Item 2), or connecting to existing MCPS tent stakes.
Adjust slips (9) (Appendix C, Section III, Item 3) to secure.
2-22
