TM 10-5410-230-13
2-5. INSTALLING THE RIGID WALL SHELTER BOOT WALL TYPE II (CONT).
NOTE
Ensure frame stays in corner of fabric to ensure proper fit.
p. Lift boot assembly (1) up using frame (2). Place ends of upright bars (2) onto swivel feet (3) and fasten using
locking pins (4).
q. Wrap remaining portion of boot assembly (1) completely around RWS (5).
r. Thread belly band webbing (7) through dee-ring buckle (8) and tighten.
s. Fasten upper and lower portions of the boot assembly (1) together with hook and pile fastener tapes (6) on driver
side.
t. If high winds are expected, install rope loops (9) (Appendix E, Item 1) and tent stakes (10) (Appendix E, Item 2) on
both sides of boot assembly. Use whichever foot loop (11) is closest to ground level or provides best hold.
2-18
