INSTALLING TEHE RIGID WALL SHELTER BOOT WALL TYPE II.

INSTALLING M577 BOOT WALL TYPE I (CONT - TM-10-5410-230-13_25

INSTALLING TEHE RIGID WALL SHELTER BOOT WALL TYPE II. (cont)

TM-10-5410-230-13 Standard Integrated Command Post Systems Bootwalls Types I II & IV Classes 1 (Green) and 2 (Tan) Manual
Page Navigation
20

TM 10-5410-230-13 2-5. INSTALLING TEHE RIGID WALL SHELTER BOOT WALL TYPE II. NOTE If a wall assembly is in place where Boot Wall is to be installed, it must be removed prior to installation. See paragraph 2-3 for removal instructions. a. Unpack the Rigid Wall Shelter (RWS) Boot Wall and inspect in accordance with Table 2-1, Operator PMCS. b. Standing inside the MCPS tent, line up Boot Wall end panel (1) and fasten it to MCPS tent roof cap (2) with quick release fasteners (3). Ensure that roll-up door (4) is down (closed) and secured with hook and pile fastener tapes. c. Starting in center of Boot Wall, line up pile fastener tape on end panel assembly (1) with hook fastener tape on MCPS tent roof cap assembly (2) and press them together. Work from center outward in order to prevent wrinkles in hook and pile fastener tapes. 2-14

Privacy Statement
Press Release
Contact