INSTALLING THE S-250E BOOT WALL TYPE IV

INSTALLING THE RIGID WALL SHELTER BOOT WALL TYPE II (CONT) - TM-10-5410-230-13_30

INSTALLING THE S-250E BOOT WALL TYPE IV (CONT - TM-10-5410-230-13_32

TM-10-5410-230-13 Standard Integrated Command Post Systems Bootwalls Types I II & IV Classes 1 (Green) and 2 (Tan) Manual
Page Navigation
25

TM 10-5410-230-13 2-6. INSTALLING THE S-250E BOOT WALL TYPE IV. NOTE If a wall assembly is in place where Boot Wall is to be installed, it must be removed prior to installation. See paragraph 2-3 for removal instructions. a. Unpack S-250E Boot Wall and inspect in accordance with Table 2-1, Operator PMCS. b. Standing inside MCPS tent, line up Boot Wall end panel (1) and fasten it to roof cap (2) with quick release fasteners (3). Ensure that roll-up door (4) is down (closed) and secured with hook and pile fastener tapes. c. Starting in center of end panel, line up the pile fastener tape on end panel assembly (1) with hook fastener tape on MCPS tent roof cap assembly (2) and press them together. Work from center outward in order to prevent wrinkles in hook and pile fastener tapes. 2-19

Privacy Statement
Press Release
Contact