INSTALLING THE RIGID WALL SHELTER BOOT WALL TYPE II (CONT)

INSTALLING THE RIGID WALL SHELTER BOOT WALL TYPE II (CONT) - TM-10-5410-230-13_28

INSTALLING THE RIGID WALL SHELTER BOOT WALL TYPE II (CONT) - TM-10-5410-230-13_30

TM-10-5410-230-13 Standard Integrated Command Post Systems Bootwalls Types I II & IV Classes 1 (Green) and 2 (Tan) Manual
Page Navigation
23

TM 10-5410-230-13 WARNING Use a ground guide when backing a vehicle. Failure to observe this warning may result in death or serious injury. Make sure the radio sets are turned off for the rest of the Boot Wall installation. Personal injury may result if radio sets are used during Boot Wall installation. k. Center HMMWV with RWS (1) on Boot Wall (2) and back it up to within four to five feet of MCPS tent (3). l. Remove whip antennas (4) from their mounts (5) on rear of RWS (1). (Use folding steps on passenger side of RWS to access roof.) m. Lift top of boot assembly (2) over antenna mounts (5) on RWS (1). Place the antenna sleeves (6) over the antenna mounts (5). n. Install whip antennas (4) into mounts (5). Tighten sleeves (6) using tie tapes (7). o. Remove belly band webbing (8) from dee-ring buckle (9) and separate hook and pile fastener tapes (10) on driver side of boot assembly. 2-17

Privacy Statement
Press Release
Contact