TM 10-5410-230-13
WARNING
Use a ground guide when backing a vehicle. Failure to observe this warning may
result in death or serious injury.
Make sure the radio sets are turned off for the rest of the Boot Wall installation.
Personal injury may result if radio sets are used during Boot Wall installation.
h. Center HMMWV with S-250E shelter (1) on Boot Wall (2) and back up to within four to five feet of MCPS tent (3).
i. Remove ladder from storage bracket on rear of S-250E and ensure HMMWV tailgate is up and secured.
j. Remove web belly band (4) from dee-ring buckle (5) and separate hook and pile fastener tapes (6) on driver's side of
Boot Wall (2) and blackout wall inside.
k. Pull Boot Wall (2) over top of S-250E shelter (1). Boot wall should overlap S-250E approximately 15-18 inches.
The blackout wall should fit flush against rear of S-250E and the ladder bracket should be placed into the pocket in
blackout wall. If necessary, readjust HMMVW to attain proper fit.
l. Attach web strap hooks (7) to lifting eyes (8) located on hood of HMMWV and tighten webs straps so that blackout
wall is snug against rear of S-250E shelter.
2-21
