TM 10-5410-224-14
REPAIR OF PERSONNEL AND CARGO END PANELS
10-1. Description.
(8), and flat washers (9) to detach clamp (10).
(b) Remove three screws (1) to detach clip
The description of the personnel and cargo end
(2) and capstan (3) and remove cable assembly
panels is contained in paragraph 3-21.
(16).
10-2. Cleaning.
(c) Inside shelter, remove four screws (11),
Use a clean, soft bristle brush to remove dust,
lock washers (12) and flat washers (13) to detach
dirt, and lint from all parts and surfaces of the end
clamp (14).
panels. Wash panels with soap and water, and a
(d) Remove two screws (5) to detach latch
sponge or soft cloth.
(15).
10-3. Inspection and Repair.
(e) Replace latch (15) by securing with two
screws (5).
a. Inspection. Inspection of the personnel and
(f) Attach clamp (14) to panel with four
carge end panels is accomplished by performing
screws (11), lock washers (12) and flat washers
the following procedure:
(13).
(1) Perform inspection procedure of paragraph
(g) Replace clip (2) and capstan (3) with
cable assembly (16) in place, using three screws
(2) Check condition of reinforcement plates.
(1).
(3) Check safety cable assemblies for ease of
(h) Attach clamp (10) to clamp (14) with
operation.
cable assembly (16) in place, using two screws (7),
(4) Check condition of power entrance and
lock washers (8), and flat washers (9).
utility panels.
(2) Removal and replacement of receptacle and
(5) Check condition of exterior light and
stud assembly (fig. 3-16). To remove and replace
bracket.
receptacle and stud assembly (14) from panel,
(6) Check jack supports, mobilizer fittings,
proceed as follows:
and manual holder for security of attachment.
(a) Remove receptacle and stud assembly
(7) Check step assemblies and door handles
(14) from panel structure.
for ease of operation and general condition.
(b) Remove gasket (15).
(8) Check condition of doors and door vents.
(c) Replace gasket (15) and insert new
b. Repair. If personnel end panel or cargo end
receptacle and stud assembly (14) into panel.
panel has minor structural damage, repair the
(3) Removal and replacement of ring and stud
panel in accordance with procedures given in
assembly and lift fitting (fig. 10- 1). To remove ring
and stud assembly (1) and lift fitting (5), proceed
damaged, remove and replace the damaged part as
as follows
follows:
(a) Unscrew ring and stud assembly (1) to
NOTE
For removal and replacement of inserts, follow
remove from lift fitting (5).
instructions given in paragraph 4-8.
(b) Remove 11 fasteners (2, 3, and 4) to
detach lift fitting (5) from panel.
(1) Removal and replacement of safety cable
(c) Replace lift fitting (5) by securing with
and latch assembly (fig. 3-17. To remove and
11 fasteners (2, 3, and 4).
replace safety cable assembly (16) and latch
(d) Screw ring and stud assembly (1) into
assembly (6), proceed as follows:
threaded hole of lift fitting (5).
(a) Remove two screws (7), lock washers
