TM 9-4931-374-13&P
2-5. PREPARATION FOR MOVEMENT (cont)
(6) Remove screw (10) and disconnect cable assembly (11) from
male connector (12) on 120/208V cable assembly.
c. Stowing of ECU's.
(7) Replace screw (10).
NOTE
(8) Disconnect all connectors.
There are two ECU's furnished with the shop set. The
following instructions pertain to only one ECU.
(9) Install dust covers (13).
(10) Coil 120/208V cable assemblies and cable )n adapter
(1) Remove two straps (1) holding frame assembly (2) and
assembly. Lay on shelter floor in front of tool cabinet.
mounting hardware to back of right table (3).
2-18
