TM 9-4931-374-13&P
WARNING
The electrical system contains voltages that are
dangerous if contacted.
Before connecting or
disconnecting power cables, ensure circuit breaker on
power distribution panel connected to power source is
in OFF position.
CAUTION
Be sure power source is a 120/208-volt, 3-phase, 60-Hz
power source.
(1) Clamp wire of grounding rod (1) to terminal lug (2) of plug
connector (3).
(6) Install ECU (2) in shelter wall per TM 10-5410-224-14.
(2) Push grounding rod (1) into the ground near mating connector
(7) Store all mounting hardware in storage chest.
(4) on power distribution panel.
NOTE
Cable adapter assembly (5) is not needed if power
distribution panel is equipped with an MS90555
connector per MIL-C22992.
(3) Connect plug connector (3) of cable adapter assembly (5) to
mating connector (4) on power distribution panel.
CAUTION
Do not remove dust covers from connectors until just
prior to assembly with mating connector (4).
e. Connection of Shop Set to Power Source.
2-13
