TM 9-2330-390-14&P4-120. INJECTION PUMP REPLACEMENT (Con't).Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protectivegoggles and gloves, and use only in a well-ventilated area. Avoid contact with skin,eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame orexcessive heat. The solvent’s flash point is 100° F-138º F (38º C-59° C). If youbecome dizzy while using cleaning solvent, immediately get fresh air and medicalhelp. If solvent contacts eyes, immediately wash your eyes and seek medicalattention.Clean injection pump mounting surface of crankcase with a rag dipped in dry cleaning solvent. Ensure thatmounting surface is clean and dry.1. Install shim(s) (4) on crankcase (7).2.3.Position injection pump (2) at crankcase (7) with control rack pin (3) firmly inserted into groove of fork lever (6).Install two flange bolts (1) to injection pump (2) and crankcase (7). Evenly torque flange bolts to 84-96 lb.-in.(9-11 N lm).4. Check timing adjustment (see subparagraph d).4-347
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
