TM 9-2330-390-14&P
4-121. NOZZLE HOLDER REPLACEMENT (Con't).
1.
If removed, install two studs (7) on cylinder head (6).
N O T E
Heat seal is required if OC60D1 engine nozzle holder is being replaced with an
OC60E1 engine nozzle holder.
2.
Install copper gasket (8) heat seal (9) (if required), and nozzle holder (10) on cylinder head (6).
3.
4.
5.
Install nozzle retainer (3) over nozzle holder (10) with two nuts (2). Evenly torque nuts to 120-156 lb.-in.
(14-18 Nm).
Connect overflow hose (1) to nozzle holder (10) with clip (11).
Connect injection pipe (4) to nozzle holder (10) and tighten nut (5).
Follow-on Tasks:
Connect negative (-) ground cable to battery (see paragraph 4-45).
Start engine (see paragraph 2-20) and check for fuel leaks.
Install oil cooler cover (see paragraph 4-117).
4-351