TM 9-2330-390-14&P
4-120. INJECTION PUMP REPLACEMENT (Con't).
NOTE
Adding one shim will advance timing mark F on flywheel by approximately 1.0°-1.5°.
8.
If timing is not correct, adjust by adding or removing shims.
9.
Connect injection pipe (8) to nozzle holder (9).
10.
Install spiral case (see paragraph 4-128).
11.
Set engine speed control lever to LOW (see paragraph 2-20).
Follow-on Tasks:
Install engine (front dolly) (see paragraph 4-115).
Connect negative (-) ground cable to battery (rear dolly) (see paragraph 4-45).
Start engine (see paragraph 2-20) and check for fuel leaks.
4-349
