TM9-2330-390-14&P
4-117. OIL COOLER AND ROCKER ARM COVERS REPLACEMENT (Con't).
· Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent’s flash point Is 100°F-138°F (38°C-59°C). If you
become dizzy while using cleaning solvent, Immediately get fresh air and medical
help. If solvent contacts eyes, Immediately wash your eyes and seek medical
attention.
· Compressed air used for cleaning or drying purposes, or for clearing restrictions,
should never exceed 30 psi (207 kPa). Wear protective clothing (goggles/shield,
gloves, etc.) and use caution to avoid Injury to personnel.
1.
Clean all removed components with dry cleaning solvent and dry with compressed air. Ensure that gasket
mounting surface on rocker arm cover and cylinder head Is clean and dry.
2.
inspect all removed components for cracks, breaks, bends, corrosion, or other damage. Replace damaged
components.
1.
If removed, install oil filler plug (11) and O-ring to rocker arm cover (4).
2.
3.
Install new gasket (8) and rocker arm cover (4) on
cylinder head (10) with clamp (5) with fuel over-
flow hose (9), bolt (6) and two bolts (7).
Install oil coolercover (1) lifting hook (3), and bolt
(2) on rocker arm cover (4).
Follow-on Tasks:
· Install starter switch assembly (see para-
graph 4-131).
4-339
