TM9-2330-390-14&P4-118. CRANKCASE OIL AND OIL FILTER REPLACEMENT.This Task Covers:a.b.RemovalC.InstallationCleaning and lnspectionInitial Setup:Equipment Conditions:Materials/Parts:· Engine warm.· Lubricating oil (Item 21, 22, or 23, Appendix F)· Engine starter switch set to OFF position (see· Rags (Item 25, Appendix F)paragraph 2-20).· Dry cleaning solvent (Item 27, Appendix F)Tools/Test Equipment:· General mechanic’s tool kit (Item 30, Appendix G)· Compressor unit (Item 4, Appendix G)General Safety Instructions:· Dry cleaning solvent Is flammable and must not be used near an open flame. Use only in a well-ventilated area.· Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa).DO NOT allow dirt or dust to enter crankcase. Damage to engine will result.NOTE· Perform steps 1 through 5 to drain crankcase oil.· A suitable container should be used to catch any draining lubricating oil. Ensure thatall spills are properly cleaned.1.Remove oil filler plug (2) and O-ring (1) fromrocker arm cover (3).4-340
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
