TM 9-2330-390-14&P
4-116. FLYWHEEL ASSEMBLY AND STATOR ASSEMBLY REPLACEMENT (Con’t).
6.
7.
Release clamp (9) from stator assembly lead (11).
Remove grommet (10) from hole in crankcase (14). Pull stator assembly lead (11) through hole.
NOTE
Note location of stator assembly to aid during Installation.
8.
Remove four flange bolts (13) and stator assembly (12) from crankcase (14).
· Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent’s flash point Is l00°F-138°F (38°C-59°C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical
help If solvent contacts eyes, Immediately wash your eyes and seek medical
attention.
· Compressed air used for cleaning or drying purposes, or for clearing restrictions,
should never exceed 30 psl (207 kPa). Wear protective clothing (goggles/shield,
gloves, etc.) and use caution to avoid Injury to personnel.
1.
Clean all removed components, except grommet, with dry cleaning solvent and dry with compressed air.
4-334
