TM9-2330-390-14&P
4-116. FLYWHEEL ASSEMBLY AND STATOR ASSEMBLY REPLACEMENT.
This Task Covers:
a.
Removal
C.
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
· Engine removed (see paragraph 4-115).
· Spiral case removed (see paragraph 4-128).
Tools/Test Equipment:
Matetials/Parts:
· Rags (Item 25, Appendix F)
· Dry cleaning solvent (Item 27, Appendix F)
· Marker tags (Item 28, Appendix F)
· Three socket head capscrews, M6 x 1.00
· General mechanic’s tool kit (Item 30, Appendix G)
· Compressor unit (Item 4, Appendix G)
· Mechanical puller kit (Item 22, Appendix G)
· Torque wrench, 0-175 lb.-ft. (Item 42, Appendix G)
Personnel Required: Two
General Safety Instructions:
· Dry cleaning solvent is flammable and must not be used near an open flame. Use only in a well-ventilated area.
· Compressed air used for cleaning purposes should never exceed 30 psi (207 kPa).
NOTE
All wires should be tagged before removal. Refer to paragraph 4-18 for tagging
Instructions.
1.
Hold flywheel (2) and remove nut (5) and washer (4) from crankshaft (6).
2.
Install mechanical puller on flywheel (2) using three socket head capscrews.
3.
Using mechanical puller, remove flywheel (2) from crankshaft (6).
4.
Remove three socket head capscrews and mechanical puller from flywheel (2).
4-332
