TM 9-2330-390-14&P
Change 4 4-209/(4-210 Blank)
4-79.
STEERING STOP REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Tools/Test Equipment:
• General mechanic's tool kit (Item 30, Appendix G)
• Adjustable wrench (Item 37, Appendix G)
• Socket wrench set, 3/4 in. drive (Item 39, Appendix
G)
1.
Loosen stop nut (3).
2.
Remove stop bolt (4) from front axle (1).
3.
Remove stop nut (3) from stop bolt (4).
1.
Install stop nut (3) on stop bolt (4).
2.
Install stop bolt (4) on front axle (1) so that distance from front face of boss to top of stop bolt head is
approximately 1.50 in. (3.81 cm).
3.
Turn steering to position center steering link (2) against stop bolt (4) head. Adjust stop bolt to provide a
0.12 in. (0.3 cm) clearance between airbrake chamber (6) and aft side of axle air bag mounting plate.
NOTE
Check that tie rod end jamnut (5) does not contact steering knuckle.
4.
Tighten stop nut (3).
a.
REMOVAL
2
5
6
3
4
b.
INSTALLATION
