TM 9-2330-390-14&P
4-78. STEERING LINK REPLACEMENT (Cont).
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvents flash point is 100°F-138°F (38°C-59°C). If you
become dizzy while using cleaning solvent, immediately get fresh air and medical help.
If solvent contacts eyes, immediately wash your eyes and seek medical attention.
1. Clean steering link with dry cleaning solvent and dry with a clean rag.
2. Inspect steering link for cracks, breaks, or damaged bushing surfaces. Replace damaged steering link.
NOTE
Perform step 1 to Install detent pin lanyard assembly to center pin and steering locking
pin.
1. Thread lanyard cable (8) through ends of center pin (2) and steering locking pin (3). Secure each end with new
sleeve (7). Crimp sleeves.
4-207