TM 9-2330-390-14&P4-78. STEERING LINK REPLACEMENT.This Task Covers:a. Removalc. Installationb. Cleaning and InspectionInitial Setup:Equipment Conditions:• Front drawbar removed (see paragraph 4-53).• Tie-rod assemblies removed (see paragraph 4-77).Tools/Test Equipment:• General mechanic’s tool kit (Item 30, Appendix G)Materials/Parts:• Rags (Item 25, Appendix F)• Dry cleaning solvent (Item 27, Appendix F)• One grease fitting• One roll pin• Two sleevesGeneral Safety Instructions:• Dry cleaning solvent is flammable and must not beused near an open flame. Use only in a well-venti-lated area.Personnel Required: TwoUse extreme caution when handling heavy parts. Lifting device is required when partsweigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two personlift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of heavy partssupported only by lifting device. Failure to follow this warning may cause serious injuryor death to personnel.1. Remove steering locking pin (3) from front axle (1) and steering link (4).2. Remove roll pin (6) center pin (2) and steering link (4) from front axle (1). Discard roll pin.3. Remove grease fitting (5) from steering link (4). Discard grease fitting.NOTEPerform step 4 to remove detent pin lanyard assembly from center pin and steeringlocking pin as required.4. Cut lanyard cable (8) from ends of center pin (2) and steering locking pin (3). Discard sleeves (7).4-206
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
