TM 10-8340-243-13&P
0005
Connecting Wall Sections
1. Overlap the tent fabric at the corners of each wall (Figure 17, Item 1) by lining up the corresponding
side strips of hook and pile fastener (Figure 17, Item 2) and pressing together.
NOTE
Strap assemblies always line up with the corresponding strap assembly on the left.
2. Fasten the row of quick disconnect fasteners (Figure 17, Item 3) on the inside corners of each wall.
Draw the buckle straps (Figure 17, Item 4) tight.
3. Tighten the Corner Roof Cap guy lines (Figure 17, Item 5).
4. Fasten the quick disconnect fasteners on the outside of the wall corners and draw the buckle straps
5. Each corner of the roof cap has flaps (Figure 17, Item 7) that must overlap the corresponding wall
juncture. Pull the outside roof cap corner flaps down and press the hook and pile fasteners (Figure
17, Item 8). Make sure the strips are pressed tight, so that rainwater will stay out and interior light
cannot escape.
3
4
2
1
7
8
5
6
END OF TASK
