TM 10-8340-243-13&P
0005
Wall Assembly Setup
1. Unfold the desired wall assembly (Figure 16, Item 1), stretch it out, and position it so that the pile
fastener strip (Figure 16, Item 2) faces the hook fastener strip (Figure 16, Item 3) on the roof cap
2. The wall assembly (Figure 16, Item 1) attaches to the inside of the roof cap (Figure 16, Item 4) using
quick release fasteners (Figure 16, Item 5) first and then the hook (Figure 16, Item 3) and pile
(Figure 16, Item 2) fastener. Standing inside the tent, line the wall assembly up and fasten it to the
roof cap with the quick release fasteners. The order in which you fasten the quick release fasteners
doesn't matter, as long as they are lined up. Make sure the leg assemblies (Figure 16, Item 6) stay
inside the tent. Take care to keep the hook and pile fasteners apart until quick release fasteners are
fastened.
3. From inside the MCPS, starting in the center of the wall assembly (Figure 16, Item 1), line up the pile
(Figure 16, Item 2) fastener strip on the wall assembly with the hook fastener (Figure 16, Item 3) on
the roof cap assembly (Figure 16, Item 4) and press them together. Work from the center toward
each end in order to prevent wrinkles in the hook and pile fastener strips.
3
4
5
2
1
6
END OF TASK
