TM 10-8340-243-13&P
0005
Wall Liner Installation
WARNING
Install the correct liner to the correct wall. Mismatched liners may block exits, result in a
loss of function for the MCPS system, and restrict ventilation and climate control. Failure
to observe correct installation may result in serious injury or death to personnel.
NOTE
The liners are designed to serve as insulation, as an outside wall during daylight hours
and/or in hot weather (they breathe), and as partial dividers or privacy walls between
adjoining complexed tents.
1. Use the hook and pile fasteners to hang each liner (Figure 19, Item 1) from the roof cap liner over
the appropriate wall. Make sure the buckles (Figure 19, Item 2) face the tent interior.
2. Attach wall liners (Figure 19, Item 1) between legs (Figure 19, Item 3) of the frame and wall (Figure
hook and pile fasteners that will attach over the top of the walls and buckles that will match and attach
to the top half of the buckles just unfastened. Make sure that the center legs are covered by the liner,
and that the liner goes behind the corner legs. If tents are complexed, the liner should cover all legs
except for those on the complex corners.
3. Fasten the corners (Figure 19, Item 5).
4. Buckle the floor (Figure 19, Item 6) to the liner (Figure 19, Item 1) (3 buckles per side).
5. The entrance way wall liner door (Figure 19, Item 7) should be opened if entry/exit is desired.
Unfasten the quick disconnect fasteners and hook and pile fastener and roll the door section from one
side to the other. Buckle assemblies with quick disconnect fasteners are provided to secure the liner
open.
0005-19
