TM 10-5411-235-13
INSTALLATION OF LMS I SHELTER TO HMMWV
0038 00
8.
Position and secure rear mounting adapter (18) to shelter using screws (22, 23, 24 and 25), flat
washers (26 and 27), and lock washers (28 and 29). Do not tighten.
2
1
3
4
5
9.
On each isolator mounting screw (1), slide on isolator (male portion) (2), isolator mount washer
(3), spacer (4), and sleeve spacer (5) and secure with tape so that the hardware does not fall off
when the shelter is lifted onto the HMMWV.
10.
Repeat steps 1 through 9 for other side of shelter.
FRONT SHELTER PREPARATION
Remove bolts/plugs from the front and bottom front surfaces of shelter.
CAUTION
Do not use excessive force when tightening bolts. Damage
to equipment may occur.
1.
Position mounting angle assembly (1) on shelter and secure front section with flat washers (2),
lock washers (3), screws (4), and bottom section with bolts (5) and flat washers (6). Tighten
screws/bolts to 8-10 ft. lbs.
0038 00-8
