TM 10-5411-235-13
INSTALLATION OF LMS I SHELTER TO HMMWV
0038 00
SHELTER
REAR CORNER
19
20
18
27
29
26
24
26
28
28
21
22
5
26
6
28
VIEW A
25
23
VIEW A
17 2
1
15
13
11
7
12
9
10
13
4
14
BUMPER
16
3
10
8
1.
Secure clamping bracket and shim (1) to rear mounting bracket (2) using screw (3), flat washer
(4), lock washer (5), and nut (6). Do not tighten.
2.
Remove nuts (7), bolts (8), lock washers (9), and flat washers (10) securing curbside rear bumper
to vehicle frame. Retain nuts (7), lock washers (9), and flat washers (10).
3.
Position and secure rear mounting bracket (2) to rear bumper using (new) longer bolts (8) and flat
washers (10), lock washers (9) and nuts (7). Do not tighten bolts.
4.
Locate tail light mounting bracket (11) with tail light (12) to rear mounting bracket (2) and secure
with flat washers (13), lock washer (14), screw (15), and nut (16).
5.
Insert tail light wiring connectors through hole in rear mounting bracket (2), across top of rear
bumper and reconnect to vehicle wiring harness. Install grommet (17) in hole in rear mounting
bracket (2).
6.
On the bottom of the shelter, remove all paint and sealer from any rivet head that may come into
contact with rear mounting adapter (18). Remove any bolts/plugs from the bottom rear surface of
the shelter.
7.
Insert an isolator mounting screw (19), flat washer (20), and isolator mount washers (21) down
through each round opening in the rear mounting adapter (18).
0038 00-7
