TM 10-5411-235-13
INSTALLATION OF LMS I SHELTER TO HMMWV
0038 00
13.
Apply a thin coat of MIL-G-10924 grease to shank of towing pintle assembly.
14.
Secure towing pintle assembly to pintle extension (1) with existing washer (10), 3 washers (9),
existing nut (8), and cotter pin (7). NOTE: Do not overtighten nut; ensure pintle assembly rotates
freely when turned by hand.
15.
Tighten nuts (4) installed in step 12 to 90 ft. lbs.
REAR SHELTER PREPARATION
WARNING
Be sure shelter is properly positioned on support stands
capable of supporting 2000 lbs. Failure to observe safety
procedures when working under the shelter could result in
severe injury or death.
CAUTION
Do not use excessive force when tightening nuts. Damage
to the equipment can occur.
NOTE
During procedure, threaded holes may be fouled with
paint/primer/sealer preventing full insertion of bolts. Should
this occur, use a bottom tap to clean foreign matter from
holes.
0038 00-6
