TM 10-5411-235-13
INSTALLATION OF LMS I SHELTER TO HMMWV
THIS TASK COVERS:
Installation of Shelter and Pintle Extension Kit
INITIAL SETUP:
Tools and Special Tools
General Mechanics Tool Kit (WP 0042, Table 2, Item 1)
Materials/Parts
Refer to WP 0043
VEHICLE PREPARATION
CAUTION
Packing list and illustrations should always be retained with
the LMS Shelter for future use. Do not remove or damage
packing list.
NOTE
For shelters to be replaced or moved from one vehicle to another and for any
component of the installation mounting kit which requires maintenance, perform
only the steps which are applicable.
Prior to performing the following procedures, remove Shelter-to-Vehicle Mounting
Kit and inventory per WP 0043, Table 3.
1.
Remove wheel well side panel located on each side of vehicle. Reference HMMWV TM 9-4940-
563-13&P.
2.
Carefully feed antenna cable back through wheel well grommet, place protective cap over
connectors, and secure cables behind cross member support in wheel well.
3.
From inside the curbside rear wheel well, remove the wiring harness clamp mounting bracket.
Remove cable clamps from wiring.
4.
Remove tailgate from rear of HMMWV per TM 9-4940-563-13&P.
5.
Remove antenna mounting bracket from rear of HMMWV per TM 9-4940-563-13&P.
6.
Remove tail lights from HMMWV lower frame per TM 9-4940-563-13&P. Retain hardware.
7.
Secure tail lights (1) to tail light mounting brackets (2) and wiring ground lug (3) using bolts (4)
and washers (5) removed in step 6.
8.
Make a single cut through grommet (6) and place it around the tail light wiring (7).
9.
Remove camlock fasteners from the vehicle mounting beam located in front of the vehicle's bed,
both sides. Refer to TM 9-4940-563-13&P.
0038 00-1
