TM 10-5411-235-13
INSTALLATION OF LMS I SHELTER TO HMMWV
0038 00
5.
Due to potential variations in the HMMWV or shelter length and width, carefully align each
isolator mounting screw (6) with holes on rear mounting bracket (7). Using the slotted holes
in the respective pieces, adjust the rear mounting bracket (7) for any lateral movement
required and the mounting adapter (10) for any longitudinal movement required.
6.
Tighten all screws securing the rear mounting bracket (7) to the rear bumper and rear
mounting adapter (10) to the bottom and sides of the shelter.
7.
Repeat for the other side of shelter.
8.
Slowly lower the shelter onto the HMMWV while maintaining alignment. For each isolator
mounting screw (6), remove the tape and slide on 2 isolators (female portion) (11), isolator
mount washer (12), and flat washer (13) then secure with self-locking nut (14). Do not
tighten.
9.
Repeat for the other side of shelter.
CAUTION
Do not use excessive force when tightening bolts. Damage
to equipment may occur.
10.
Remove each front mounting screw (1) from the vehicle beam and add flat washer (2),
isolator mount washer (3), and isolator (female portion) (4) then reattach screw (1).
11.
Repeat for the other side of shelter.
12.
Once all hardware is installed, recheck and tighten all (front and rear) isolator mounting
screws/nuts to 8-10 ft. lbs.
13.
Lower the shelter all the way and remove the lifting sling from the lift rings
0038 00-13/(14 Blank)
