REMOVAL PROCEDURES (CONT) - TM-10-5411-203-13

REMOVAL PROCEDURES (CONT) - TM-10-5411-203-13_54

REMOVAL PROCEDURES (CONT) - TM-10-5411-203-13_56

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
50

TM 10-5411-203-13 2-5. REMOVAL PROCEDURES (CONT) b. Removal of Complexing Kit Passageway - Type II, Class A and Class B (ISO Shelter to TEMPER) (Cont) WARNING The Complexing Kit Passageway includes two ramps and a stairway. The ramps weigh ap- proximately 145 pounds (65.77 kg) and 195 pound (88.45 kg) respectively, and the stairs weigh approximately 70 pounds (31.75 kg). Four persons are required to handle each of these components. Attempting to lift or carry any of these items by yourself could result in serious injury or damage to the equipment. NOTE It may be necessary to rotate swivel feet slightly to allow removal of locking pins (1.1) Remove locking pins (1) and remove exterior frame assembly upright bars. (2) Using flat-tip screwdriver, Remove captive screws (3) that secure swivel feet (2) to ISO shelter (4). Set swivel feet aside. (3) Untie becket lacing using the following steps: (a) Remove becket flap loops from wooden toggles on sides of connector. (b) Untie half-hitch knots (1) in becket lacing attaching connector assembly (2) to TEMPER (3). (c) Unlace becket lacing until connector assembly is free from TEMPER. 2-44

Privacy Statement
Press Release
Contact