REMOVAL PROCEDURES (CONT) - TM-10-5411-203-13

REMOVAL PROCEDURES (CONT) - TM-10-5411-203-13_56

REMOVAL PROCEDURES (CONT) - TM-10-5411-203-13_58

TM-10-5411-203-13 Complexing Kit Passage-ways Complexing Kit Passageways Type II Class A Class B Type I Manual
Page Navigation
52

TM 10-5411-203-13 2-5. REMOVAL PROCEDURES (CONT) b. Removal of Complexing Kit Passageway - Type II, Class A and Class B (ISO Shelter to TE.MPER) (Cont) NOTE The next procedure requires two persons in- side and two persons outside of the ISO shelter. (7) Remove weather barrier (1) from ISO shelter (2) using the following steps: (a) Unlatch all inside roof panel latches. (b) Using two hinged roof support struts (3), push up hinged roof panel (4) from inside ISO shelter (2). (c) Rotate roof support struts (3) to upright position. Lower struts to floor until hinged roof panel (4) is supported on struts (3). WARNING When installing or removing weather barrier between hinged roof panel and hinged sidewall or endwall of ISO shelter, take care to avoid getting fingers caught. Failure to do so may result in serious injury. (d) Pull weather barrier (1) out of open space between hinged roof panel (4) and ISO shelter (2). (e) Lower hinged roof panel (4) onto ISO shelter (2) using roof support struts. (f) Store roof support struts in stowage brackets. (g) Latch all inside panel latches to secure hinged roof panel (4) to ISO shelter (2). (8) If Type II, Class B, disassemble stairway by removing locking pins and separating joined stairway assemblies. (9) Remove ramp or stairway from inside Complexing Kit Passageway. Place ramp or stairway inside ISO shelter or TEMPER. 2-46

Privacy Statement
Press Release
Contact