ENDWALL CLOSEOUT PANEL REPLACEMENT

HINGED PANEL LEVELING JACK ASSEMBLY REPLACEMENT (cont) - TM-10-5411-200-14_73

SIDEWALL CLOSEOUT, ECU INTAKE, AND ECU RETURN PANELS REPLACEMENT - TM-10-5411-200-14_75

TM-10-5411-200-14
Page Navigation
54

TM 10-5411-200-14 T.O. 35E4-177-1 3-7. ENDWALL CLOSEOUT PANEL REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP Standard Tools Personnel-2 General mechanics tool kit REMOVAL W A R N I NG When hinged floor is in deployed position, do not disconnect support cable from hinged floor until stop plates on load balancer (inside shelter) have been locked with quick release pins to prevent return of support cable. 1. Move flexible electrical cable to facilitate removal of endwall 2. Inside shelter, loosen twelve captive screws (1) and remove endwall closeout panel (2). INSTALLATION NOTE Endwall closeout Panel (2) iS stowed on outside of hinged sidewall when-not in use. Position endwall closeout panel (2) against shelter endwall and secure by tightening twelve captive screws (1), placing bottom end in first 3-8 CHANGE 2

Privacy Statement
Press Release
Contact