TM 10-5411-200-14T.O. 35E4-177-13-4.(cont)INSTALLATION1.Position post of area light assembly (3) in two brackets (4) onshelter and tighten two wingnuts (2) to secure light to shelter.2.Connect area light assembly connector (1) to power entry panel.3.Place circuit breaker CB8 to on position.3-5.HINGED ROOF AREA CEILING LIGHT REPLACEMENTThis tasks covers:a. Removalb.InstallationW A R N I N GThis fixture contains voltage that is dangerousif contacted.Before replacing hinged roof areaceiling light, make sure that electrical power iscompletely disconnected from circuit involved.REMOVAL1.Place ceiling light switch and circuit breaker CB6 to off position.2.Unplug cable connector (1) from receptacle outlet (twist-lock typeconnector) .3.Retract plunger (2) and slide hinged roof area ceiling light (3)toward cable end to disengage two brackets (4) from four captiveStudsINSTALLATION1.Placeholes2.Slide(5) in hinged roof.hinged roof area ceiling light (3) against hinged roof within two brackets (4) over four captive studs (5).light away from cable end to engage two brackets (4) on fourcaptive studs (5).3.Plug cable connector (1) in receptacle outlet.3-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
