TM 10-5410-224-14
1. Fastener (4)
7. Fastener (4)
8. Shear (4)
2. Strike (2)
3. Screw (3)
9. Rivet (4)
4. Washer (3)
10. Strike
5. Strike
11. Rivet (4)
6. Fastener (4)
12. Strike (2)
(9) Removal and replacement of personnel
(15), and flat washers (16) to detach case (17), to
door handles and lock rods (fig. 3-20). To remove
shim (18), and spacer (19).
and replace door handles (2 and 7), lock rods (21)
NOTE
Replace the entire assembly in accordance with the
and associated hardware, proceed as follows:
following steps.
(a) Remove groove pin (1) from handle (2)
and remove handle and washer (3).
(f) Replace case (17) with shim (18) and
spacer (19) in proper position and secure with four
(b) Disengage two lock rods (21) from ec-
centrics on center case assembly (25) and remove
screws (14, lock washers (15), and flat washers
lock rods.
(16).
(c) Remove four bolts (22) and washers (23)
(g) Attach bracket (7) to door using three
to detach center case assembly (25) and spacer
screws (4), lock washers (5), and flat washers (6).
(26). Also remove four rubber washers (27) and
(h) Position tube (28) in hole in door and
tube (28).
insert square shaft of handler (2) through handle
bracket and tube (28).
(d) Detach handle (7) by removing three
(i) Slide four rubber washers (17) onto
screws (4), lock washers {5), and flat washers (6).
handle shaft.
(e) Remove four screws (14), lock washers
